PROTON would like to refute the recent image that has been circulating on social media, alleging not jump-starting certain Proton models as it will cause irreparable damages to the Transmission Control Unit (TCU). Proton has confirmed that all cars can be jump-started.
However, like other carmakers, PROTON cars have been equipped with electronic systems which are sensitive to power surge. PROTON wish to provide a more accurate guide on this subject and assure PROTON owners that it is safe to use jumper cables to start the engine as long as proper steps are followed, as stated in the PROTON car Owner’s Manual.
In view of this, PROTON would like to take this opportunity to clarify that the right procedure to jump-start the car would be to connect the (+) battery from the assisting car to the (+) terminal of the battery of the affected car. However, the (-) terminal from the assisting car must be connected to the body of the affected car, NOT to its (-) terminal. When in doubt, owner can refer to the Owner’s Manual.
The steps to be taken as stated in the Manual when using jumper cables connected to a battery from another vehicle, include:
- Vehicles should be close enough so that the jumper cables can be connected, but be sure that the vehicles aren’t touching each other. If they are, it could cause an undesirable ground connection. It will not be possible to start the vehicle, and the bad grounding could damage the electrical systems (Transmission Control Unit, TCU).
- The assisting vehicle must have a 12-volt battery and the capacity (Ah) of the booster battery should not be significantly lower than that of the discharged battery, this is to avoid damage of circuit shorting both vehicles.
- Only use jumper cables with insulated battery clamps.
- Vehicle must be positioned in “P” (PARK) for automatic transmission and “N” (NEUTRAL) for manual transmission.
- Turn off the ignition on both vehicles beforehand.
- When connecting the booster cable, do not connect the positive (+) cable to the negative (-) terminal or it can cause sparks and battery can explode.
- The negative jumper cable (black) must never be clamped to fuel lines with metal sheath or to the fuel filter or brake lines as this could cause a fire.
- Start the engine in the vehicle, which has the booster battery, let the engine idle for a few minutes and then start the engine in the vehicle with the discharged battery.
- After the engine is started, disconnect the cables in reverse order.
AD: Interested to buy an Emergency Jump Starter kit? You can now purchase ResQFrog Jump Starter kit directly from FastMotoring.com. ResQFrog is a true ultra handy & portable multifunctional tools for all motoring enthusiasts and professionals.
- 4 in 1 functionality: Jump Starter, LED Torch Light, Roadside Emergency Flashing Lights and 2.1A USB Power Bank
- Support 4 Cylinders / V6 / V8 and V12 Petrol Engine with 500A Peak Current
- Roadside Emergency Flashing Lights for Safety
- Anti Bumping Hard Rubber Material for Durability
- Overload Warning & Protection (Reverse Polarity Protection and Over-Charge/Over-Discharge Protection)
- Suitable for Vehicle, Boat, Light Truck and Motorbike
- Comply to Australian/New Zealand Standards (with RCM)
- One (1) Year Warranty (Return to Base)
How much it cost? RM499 including delivery to Malaysia Nationwide.
How to buy? Email to [email protected]